AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Manual service rotel ra 1111/19/2022 Do not allow foreign objects to get into the enclosure. Do not place objects filled with liquids, such as vases, on the unit. Do not expose the unit to dripping or splashing. WARNING: To reduce the risk of fire or electric shock, do not expose the unit to moisture or water. Servicing to qualified service personnel. WARNING: There are no user serviceable parts inside. The RS232 connection should be handled by authorized persons only. Temperature such as sunshine, fire or other heat sources. The batteries in the remote control should not be exposed to excessive Immediately stop using the component and have it inspected and/or serviced by a qualified service agency if:-¢ The power supply cord or plug has been damaged.-¢ Objects have fallen or liquid has been spilled into the unit.-¢ The unit has been exposed to rain.-¢ The unit shows signs of improper operation.-¢ The unit has been dropped or damaged in any way. Use Class 2 wiring for speaker connections to ensure proper installation and minimize the risk of electrical shock. Use caution when moving the unit in a stand or rack to avoid injury from a tip-over. Use only with a cart, stand, rack, bracket or shelf system recommended by Rotel. Use only accessories specified by the manufacturer. The power cord should be unplugged from the wall outlet during a lightning storm or if the unit is to be left unused for a long period of time. Pay particular attention to the power cord at the plug and where the cord exits the back of the unit. The disconnect device shall remain readily operable.ĭo not route the power cord where it will be crushed, pinched, bent, exposed to heat, or damaged in any way. In order to completely disconnect the apparatus from the supply mains, the main plug of the power cordset should be unplugged from the mains (AC) outlet.The stand-by LED indicator will not be lit up to show the power cord is unplugged. The main plug of the power cordset is a disconnect device of the apparatus. If the supplied plug does not fit your outlet, please consult an electrician for replacement of the obsolete outlet. Do not defeat grounding and/or polarization safety provisions. A grounding plug has two blades plus a third grounding prong. A polarized plug has two blades, with one wider than the other. (USA: 120 V/60Hz, EC: 230V/50Hz)Ĭonnect the component to the power outlet only with the supplied power supply cable or an exact equivalent. The unit must be connected to a power supply only of the type and voltage specified on the rear panel. The device must be located in an open area that allows access to the cord connector. WARNING: The rear panel power cord connector is the mains power disconnect device.
0 Comments
Read More
Leave a Reply. |